TS100 is not working properly after updating the IronOS in it.

[Blamelt61122]

TS-100 is giving a black screen after upgrading to v2.22. After seeing its not working I downgraded it to v2.06 now its working but not properly (litteraly unusable).

I am using my TS-100 for 2 years with IronOS and yesterday and I decided to update the IronOS to v2.22. When i dragged and dropped the v2.22 hex file in my TS-100 disconnets and reconnects very early. After I did this my TS-100 started to giving me a black screen without doing anything. Whatever I did I failed to copy the v.2.22 .hex file into my TS-100. After i decided to try an older version of IronOS. I did the same upgrading process with the v2.06 and it uploaded the hex file and this time my TS-100 did not disconnected early and I saw the .RDY file too but there is still a problem... when i turn on my TS-100 the screen is flickering like crazy. (its not flickering in the DFU menu) the tip heats and I can increase and decrease the tempreture with barely seeing the menu. After I did soldering for about 15 seconds it goes to start menu and stops heating until i press A to give the heating command. İt does this like in a loop heats for 15 seconds and than stops. İts litteraly unusable like this.

Its expected to oparate with v2.22 with out any problem. At least with v2.06 version because i was using it with IronOS for like 2 years.

• Device: TS-100
• Release: I dont remember the release date and i cant see because the screen is flickering too much.
• Power adapter being used: 5S 5P battery pack

I think the main problem why i cant drag and drop the v2.22 version. Its probably because my TS-100 has a clone STM32 chip and the v2.22 is 100KB is too much for my TS-100. When i try a version like v2.06 (88KB) its uploading but working so bad. And its DFU version is DFU 3.48

What should i do for fix this issue please help. If anyone has the stock frimware please drop it to your answer because i cant find it.